Battery-tender High Frequency On Board Battery Charger 48V @ 10A Manuel d'utilisateur télécharger pdf

Deltona Transformer Corporation

High Frequency SMT Golf Car Chargers

Battery Tender Battery Charger® Models:

12 Volt 20 Amp, 24 Volt 20 Amp, 36 Volt 15 Amp, 48 Volt 10 Amp

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS: This manual contains important

safety and operating instructions for the Battery Tender Battery

Charger® High Frequency SMT Golf Car Chargers. CAREFULLY

READ THESE INSTRUCTIONS BEFORE USING THESE BATTERY

CHARGERS.

WARNING AND CAUTION LABEL DEFINITIONS:

WARNING

WARNING indicates a potentially hazardous situation, which, if not

avoided, could result in serious injury or death.

CAUTION

CAUTION indicates a potentially hazardous situation, which, if not

avoided, may result in minor or moderate injury.

CAUTION

CAUTION used without the safety alert symbol indicates a potentially

hazardous situation that if not avoided, may result in property damage.

GENERAL PRECAUTIONS

WARNING

Battery posts, terminals and related accessories contain lead and lead

components, chemicals known to the State of California to cause cancer

and birth defects or other reproductive harm. Always wash your hands

after handling these devices.

WARNING

Do not operate the battery charger with damaged AC power cords or

plugs or DC output cords or accessories – Replace damaged AC & DC

cords or accessories before using the charger. Replacement items can

be purchased from authorized Deltran charger product dealers.

CAUTION

WORKING WITH LEAD ACID BATTERIES AND BATTERY CHARGERS:

All lead acid batteries have the potential to emit gasses that may combine into

a combustible or explosive mixture. In many cases, it is possible that lead acid

batteries will emit these gasses during normal discharge and charging

operations. Because of this potential danger, it is important that you follow the

precautions recommended by both the battery and battery charger

manufacturers before using either one.

USING MANUALS: Study all of the battery manufacturer's precautions and

specific recommendations for safe operation such as not removing cell caps

while charging and the recommended rates of charge (charger output current).

CAUTION

CHARGER VOLTAGE COMPATIBILITY: NEVER use a battery charger

unless the battery voltage matches the output voltage rating of the charger.

For example, do not use a 12-volt charger with a 6-volt battery and vice-versa.

CHARGER LOCATION: LOCATE the charger as far away from the battery as

is allowed by the length of the output cable harness. NEVER set the charger

above the battery. NEVER set the charger on a surface constructed from

combustible material. NEVER place the battery, the charger, or any of the

electrical connections between them in an area that is likely to become wet.

EXCESSIVE MOISTURE: Do not expose the battery charger or any of its

electrical connections (either AC or DC) to rain, snow, or extremely high,

condensing humidity.

CHARGER ATTACHMENTS: Do not use attachments that are not

recommended or sold by the charger manufacturer. To do otherwise may

result in the risk of electric shock, fire, or possibly some other unforeseen

potential personal injury situations.

HANDLING POWER CORDS: When handling electric power cords, always

pull by the plug rather than by the cord. This will reduce the risk of damage to

both the plug and cord, and it will minimize the likelihood of electric shock

resulting from that damage.

LOCATION OF POWER CORDS: Make sure all electric power cords are

located so that they cannot be stepped on, tripped over, or otherwise

subjected to damage or stress.

MONITORING SEALED & NON-SEALED BATTERIES: When leaving a

battery charger connected to either a sealed (AGM or GEL) or non-sealed

(flooded battery) for extended periods of time (weeks, months, etc.),

periodically check the battery to see if it is unusually warm. This is an

indication that the battery may have a weak cell and that it could go into a

thermal runaway condition. If the battery releases an excessive amount of gas

or if the battery gets hotter than 130°F (55°C) during charging, disconnect the

charger and allow the battery to cool. Overheating may result in plate

distortion, internal shorting, drying out or other damage. For flooded batteries,

also check individual cell fluid levels against manufacturer's recommendations

for safe operation.

WARNING

ELECTRIC SPARK & OPEN FLAME: NEVER smoke or allow a source of

1 2 3 4 5

PERSONAL PRECAUTIONS 2

Résumé du contenu

Page 1

1 Deltona Transformer Corporation High Frequency SMT Golf Car Chargers Battery Tender Battery Charger® Models: 12 Volt 20 Amp, 24 Volt 20 Amp, 3

Page 2 - PERSONAL PRECAUTIONS

3 electric spark or open flame in the vicinity of the battery or engine. (For example: Don't charge the battery next to a gas water heater.) V

Page 3

5 3. Connect the AC power plug to the 120 VAC electrical service outlet. Then follow the normal start up procedures for the Battery Tender Battery

Page 4

7 Estimated Time to Recharge (Typical Values) Battery Type: Group 31: 100 Ah Typical 8D: 200 Ah Typical Charger Output Current 80% Complete Opt

Page 5

9 Three packs are shown: 4 separate 6 volt batteries in series, 2 separate 12 volt batteries in series, and 3 separate 8 volt batteries in series.

Plus de documents pour Fournisseurs d'énergie Battery-tender High Frequency On Board Battery Charger 48V @ 10A

Voir le document Battery-tender High Frequency On Board Battery Charger 48V @ 10A Manuel d'utilisateur

Battery-tender High Frequency On Board Battery Charger 48V @ 10A Manuel d'utilisateur (1 pages)

Commentaires sur ces manuels

Pas de commentaire

Battery-tender High Frequency On Board Battery Charger 48V @ 10A Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Fournisseurs d'énergie Battery-tender High Frequency On Board Battery Charger 48V @ 10A . Battery Tender High Frequency On Board Battery Charger 48V @ 10A (PN 022-0170-1) User Instructions User Manual Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Fournisseurs d'énergie Battery-tender High Frequency On Board Battery Charger 48V @ 10A

Commentaires sur ces manuels

Produits connexes et manuels pour Fournisseurs d'énergie Battery-tender High Frequency On Board Battery Charger 48V @ 10A